Water Treatment - Teuco 630HU Manual De Uso

INSTRUCTIONS FOR USE
4 - FILLING THE MINIPOOL
Fill the pool until the water is up to the rim.
Open all section valves along the pipelines of the
whirlpool system.
Check that there are no leaks from pipes or fittings.
5 - POWERING UP THE SYSTEM
Set the main switch at the electrical control panel to the
ON position
6 - BLEEDING THE WHIRLPOOL PUMPS (if
necessary)
Start and run the whirlpool pumps 1 and 2, operating
the switches internally of the control panel.
In the unlikely event that the operation of the system
should be noisy and/or lacking in performance,
proceed to bleed the whirlpool pumps.
With the pumps switched off, loosen the nut
on the pressure pipeline of each
whirlpool pump until water emerges.
Retighten the nut.
Start up the whirlpool pumps.
Repeat the operation if necessary.

WATER TREATMENT

Treat the water using the products supplied by Teuco, as described in the accompanying manual.
Other equivalent proprietary products can also be used.
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the
quality of the water is properly maintained and ensure correct operation of the system.
630HU
GB
17 17