Installation Hardware; Name Of Parts; Required Tools; Installation - Sears Kenmore 580.72066 Manual Del Propietário

INSTALLATION HARDWARE
NO. NAME OF PARTS
t Curtain
2 Curtain Frame
3 Upper Guide
4 Side Guide
5 Support Bracket
6 Bracket
7 Leveling bolt & nut
8 Bolt
9 Nut
10 Washer
11 Side Guide seal
12 Foam Seal Strip
13 Window Track Seal
14 L Bracket
t 5 Screw (Type A)
16 Screw (Type B)
17 Screw (Type C)
REQUIRED TOOLS;
Q'TY
1
1
1
2
1
t
t
2
2
2
1
1
1
1
9
3
8
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end wrench or adjustab e wrench
• 1/4-inch hex socket and ratchet
• Tape measure
• Electric drill
• 1/4-inch ddll bit
1
-6-
INSTALLATION
Pick a location that will allow the air conditioner to
blow the cold air into the area you want. Windows
usecl for installation must be strong enough to
support the weight of the air conditioner. Good
installation with special attention to the proper
position of the unit will lessen the chance that
service will be needed.
When cooling more than one room, installation
location is very important. To cool your rooms, cold
air must be blown from the air conditioner in a
straight path.
HORIZONTAL SLIDING
WINDOW INSTALLATION
E_ Loosely attach the Support Bracket to the
bottom of Bracket using Bolts, Washer, and Nuts.
Attach the Leveling bolt and nut. (Fig. 1)
Bracket
Support Leveling Bolt & Nut
FIG. 1
_ Remove protective backing from Window Track
Seal and apply seal to window track. (Fig.2)
_ Measure and lightly mark a line 8-1/4 inches
from window jamb. Center the Support Bracket
assembly on the window track and fasten with
4 Type C screws.(Fig. 2)
Window Jamb __ii"_.. I
\\ I
FIG. 2