Installation; Installation Requirements - Sears Kenmore 580.72059200 Manual Del Propietário

Acondicionador de aire de ventana
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
22 to 36 inches (558mm to 914mm) (FIG. 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 14 inches (356rnm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
FIG. 1
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown on
the unit nameplate (found on left side of cabinet).
All models are equipped with a 3-prong service plug to
provide proper service and safe positive grounding. Do
not change plug in any way. Do not use an adapter
plug. If your present wall outlet does not match your
plug, call a qualified electrician to make the necessary
corrections. SAVE CARTON and this OWNER'S
MANUAL for future reference. The carton is the best
way to store unit during winter or when not in use.
To avoid risk of personal injury, property damage, or
product damagedue to theweight of this device and
sharp edgesthat may be exposed:
• Air conditionerscovered in this manual pose an
excessiveweight hazard.Two or more people are
needed to move and install the unit.
To prevent injury or strain,use proper lifting and
carrying techniqueswhen moving unit.
• Carefully inspectlocation where air conditioner will
be installed.Be sure it will supportthe weight of
the unit over an extended period of time.
• Handleair conditioner with care. Wear protective
gloves whenever lifting or carryingthe unit. AVOID
the sharp metal fins of front and rear coils.
• Make sure air conditionerdoes not fall during
installation.
INSTALLATION HARDWARE
NAME OF PARTS
Q'TY
SHORT SCREW
11
WOOD SCREW
5
L BRACKET
3
FOAM STRIP
1
FOAM SEAL
1
SIDE CURTAIN
2
DRAIN PIPE
1
SUPPORT BRACKET
1
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• 3/8-inch open end
wrench or adjustable
wrench
• 1/4-inch hex socket
and ratcher
• Tape measure
• Electric drill
• 1/4-inch drill bit
-5-

Capítulos

Tabla de contenido
loading

Tabla de contenido