Cleaning The Foam Pre-Filter; Replacing The Hepa Filter - Kenmore Premalite 721.31160 Manual De Instrucciones

78017_Kenmore vac_EN_final

Cleaning the Foam Pre-Filter

For optimal performance, check filters
regularly and clean when necessary.
CAUTION
A wet filter can cause permanent
damage to the vacuum cleaner. Be
sure filters are completely dry before
reinstalling.
To Clean the Pre-Filter:
1. Remove the dust bin from the
vacuum cleaner.
2. Lift up on the dust
bin lid release and
open the lid.
3. Lift out the foam
pre-filter and
separate the 2
pieces.

Replacing the HEPA Filter

Your vacuum cleaner features a HEPA
filter for optimal exhaust filtration. This
filter cannot be cleaned and should be
replaced annually for proper
performance.
To Replace the HEPA Filter:
1. Remove the dust bin from the
vacuum cleaner.
2. Open the HEPA filter cover.
3. Turn the filter
counterclockwise
until the arrows line
up, then lift out the
HEPA filter.
10/17/07 9:00 AM
CARE & CLEANING
4. Shake out any excess
dirt or debris, and rinse
the pre-filter and filter
frame with clean water.
5. Place on a towel or
paper towel and allow
to dry. Make sure the
pre-filter and filter frame
are completely dry
before reinstalling.
NEVER operate the vacuum cleaner
with wet filters or components!
If you notice a loss of suction and
cleaning the pre-filter does not help,
you need to replace the pre-filter.
Purchase Kenmore replacement
pre-filter MDJ37614401.
4. Insert a new filter, then turn the filter
clockwise until the arrows line up to
lock it into place.
5. Lower the HEPA filter cover.
Purchase Kenmore replacement HEPA
filter ADQ33064201.
17
Page 17