Troubleshooting - Elta 6698RB Manual De Instrucciones

TROUBLESHOOTING

If you experience any problem with this system, review the list below before you contact the customer
service.
WARNING: Never open the device. Always refer service or maintenance to authorized customer
service personnel.
SYMPTOM
GENERAL
No sound
RADIO
Poor reception
CD/MP3
CD skips
Display: - - -
SPECIFICATIONS
General
Power Supply:
Power Consumption:
Frequency range:
Audio
Speaker impedance:
Dimensions:
Weight:
Subject to change without prior notice.
POSSIBLE CAUSE
Volume is set too low.
Batteries exhausted.
Batteries inserted incorrectly.
Mains cable not connected.
Weak signal.
Interferences by other
appliances (TV sets, VCRs,
computers, etc.).
CD/MP3 dirty or damaged.
The unit was jolted.
No CD inserted.
CD is dirty or damaged.
Condensation in laser lens.
CD-R/RW is empty or not
finalized.
AC 230V~50Hz
DC 9V (6 batteries type LR14 / UM-2 / C, 1.5V)
(batteries not supplied)
13 Watt
AM 525 – 1615kHz
FM 87.5 – 108MHz
8 Ohm
approx 239 x 205 x 121 mm
approx 1,4 kg
SOLUTION
Adjust the volume.
Change the batteries.
Observe polarity.
Connect mains cable correctly.
Adjust antenna:
FM: Telescopic antenna.
AM: adjust unit.
Keep distance to other
appliances.
Replace or clean the disc.
Keep the unit steady during
operation or put it down.
Insert a CD, CD-R or CD-RW.
Replace or clean the CD.
Wait until the laser lens is
completely dry (approx. 1 hour).
Finalize the CD-R/RW.
21.