Makita JS1600 Manual De Instrucciones página 5

Some tools have one or more thin washers between the
upper blade and the blade holder. Be sure to use the
same number of thin washers when reassembling.
1
2 3
4
NOTE:
• No thin washers are used for the lower blade.
Install the upper blade and tighten the upper blade secur-
ing bolt with the hex wrench. Press up on the upper blade
while tightening it.
After securing the upper blade, be sure that there is no
gap left between the upper blade and the beveled sur-
face of the blade holder.
1
2
3
When installing the lower blade onto the yoke, the lower
blade should be pressed against the yoke so as to be
contacting the beveled portions A and B of the yoke and
the tip C of the lower blade positioning screw while you
tighten the lower blade securing bolt. There must be no
clearance between A, B and C during installation.
004680
1. Thin washers
2. Blade holder
3. Upper blade
4. Upper blade
securing bolt
004681
1. Tighten
2. Upper blade
1
securing bolt
2
3. Upper blade
3
004683
1. Blade holder
2. Upper blade
securing bolt
4
3. Upper blade
4. No gap allowed
2
1
1
2
NOTE:
• The lower blade positioning screw is factory-
assembled. Do not tamper with it.
OPERATION
Holding material
The materials for cutting should be fastened to the work-
bench by means of workholders.
Shearing method
Keep the shear moving parallel with the material.
5
004686
1. Lower blade
2. Tighten
3. Yoke
3
004687
1. Yoke
3
2. Lower blade
positioning
screw
3. Lower blade
A
B
C
004699
1. Workholder
1
004701