Boiling Water - Redmond SkyKettle RK-M170S-E Manual Del Usuario

Remove all wrapping materials and stickers except for the
serial number identification sticker!
After the appliance transportation or storage at low
temperature keep it at room temperature for at least two hours
before plugging in.
Wipe the base of the appliance with a damp cloth, then let it
dry. You may notice foreign smell when using the appliance for
the first time. This does not mean its malfunction.
You are advised to boil water in the kettle a few times before
the first use to get foreign smell out and disinfect the appliance.
II. OPERATION
(scheme A3 , p. 5)
Before use
Place the kettle and base on a hard, even, dry flat surface away
from other objects or surfaces which may be damaged by steam.
NOTE: the appliance is to be used only for heating and boiling
water.
After connecting the kettle to the mains power supply the indicators
on the base will light up for 1 second. A short signal is emitted and
the appliance switches to standby mode (no indicator light).
Water-temperature maintenance mode
This mode switches on automatically after heating and allows
a set water temperature to be maintained (40, 55, 70, 85 or
95°С) for 12 hours. If the water falls below the set temperature,
the heating element switches on automatically. The water is
not reboiled. At the end of the process, the appliance emits 5
short signals and switches to standby.

Boiling water

1. In the standby mode, press 100°C. The indicator lights up.
2. If you want to keep the water at a set temperature after
boiling, press the relevant temperature button (40, 55, 70,
85 or 95°С). The indicator lights up.
The temperature can be set or changed in the same way during
or after boiling.
3. Press and wait about 3 seconds: the
up and the water starts to heat up.
4. When the water has boiled, depending on the settings:
• the kettle switches back into the standby mode (no indicator
light);
• the kettle switches into the temperature­maintenance mode
(the and temperature indicators light up).
5. Press to interrupt the heating process or switch off the
automatic temperature­maintenance mode.
Heating water without boiling
This is the recommended mode for bottled artisan or filtered water.
Water which has not been boiled retains its natural properties,
which is particularly important when brewing premium teas.
1. In the standby mode, press
2. Within 5 seconds, press the temperature button to set the
water temperature (40, 55, 70, 85 or 95°С). The indicator
lights up.
If the temperature is not set within 5 seconds, the appliance
switches to the standby mode (no indicator light). The
GBR
RK-M170S-E
indicator lights
. The indicator lights up.
9