Waring Commercial DME70MK Manual De Operación página 3

For Waring products sold outside of the U.S. and Canada, the warranty is the
responsibility of the local importer or distributor. This warranty may vary according
to local regulations.
WARNING: This warranty is void if used on Direct Current (D.C.)
• Do not fill above max line.
• After adding materials to be mixed, place container on mixer so that its top rim
engages the spring-loaded on/off switch actuator knob. Slide actuator knob
upward with rim of container to start motor. Seat bottom of container onto
container support.
• This drink mixer is intended for mixing liquids only. When mixing is finished,
disengage container from support and carefully lower it, allowing spring-loaded
switch knob to slide back down and stop motor.
• On two-speed models, Lo (I) or hi (II) speed operation is selected by a rocker
switch located on the top of the mixer housing.
• Counter-top models are equipped with a U-shaped stabilizing leg on the base of the
unit. For maximum stability, the leg should be unfolded and fully seated in position,
projecting from the rear of the base.
MOTOR
The motor requires no greasing or oiling. Sealed-in lubrication gives the unit
lifetime-smooth operation.
POWER SUPPLY CORD
The power supply cord should not be replaced by the end user. The power supply
cord should only be replaced by the manufacturer's authorized importer (or, in the
United States and Canada, by an authorized service center). For repairs or
further questions, please contact the manufacturer's authorized importer (or, in the
United States and Canada, an authorized service center).
2
Warranty
Operation
Maintenance