Use Of Machine - Apach ASM32F 2S 3PH Instrucciones Originales

USE OF MACHINE

Below, a series of sequences are described, for the correct use of the machine:
BEFORE STARTING WORK MAKE SURE THAT THE MACHINE IS PERFECTLY CLEAN IN
PARTICULAR, THE SURFACES OF BOWL, THE SPIRAL AND OF THE CENTRAL COLUMN
THAT HAVE CONTACT WITH THE FOOD PRODUCTS. IF NECESSARY CLEAN THEM
FOLLOWING INDICATIONS.
Lift the protection "I" and pour the ingredients necessary for the mixture into the bowl, then lower the
bowl protection and activate the rotation of the bowl and the spiral as described below.
To visually check the consistency of the dough, or to add further ingredients, it is possible to do it through
the protection grid, without lifting it and thus interrupting the operation of the machine.
Lifting the protection, the machine stops: at closing, it is necessary to press button 1 again to restart the
rotation of the bowl.
Start-up situation with "machine off":
 Rotate the protection differential switch to the ON position, coordinated with the main earthing
system, placed upstream of the machine in the user's system;
 Turn the timer knob clockwise and select the desired working minutes for the timed cycle.
 Press Button 1 that activates rotation of the bowl and the spiral
CHECK AGAIN THAT IT IS THE BLOW AND THE SPIRAL, WHEEL BOTH CLOCKWISE.
Start-up situation with "machine powered":
To re-start work, following suspension of the work, press button 1 having restored the safety present.
Start-up situation with "machine in emergency mode" (example thermal protection tripped):
 switch off the machine, with the sequence of commands indicated in point "MACHINE SWITCH
OFF";
 leave the electric motor to cool for approx. half an hour;
 start the machine, with the sequence indicated in point "START-UP SITUATION WITH MACHINE
OFF".
Machine switch off
For total machine switch off, from the work terminated or shut-off condition, you need to:
 Press Button 0 that terminates rotation of the bowl and the spiral.
 Rotate the knob on the timer in position 0.
 Rotate the protection differential switch to the OFF position, coordinated with the main earthing
system, placed upstream of the machine in the user's system, which disconnects the machine from
the electrical power supply.
Note: In a machine fed electrically by three-phase, if the rotation of the bowl is opposite the way shown
by the arrow it is necessary to follow these indications for the functioning and every time you change the
electric plug:
 Stop the machine;
 Take the plug out.
 Reverse on the plug the position of two phases (ex. L1 with L2) .
 Restart the machine and verify if the bowl is rotating the right way;
 Start the machine without using it, let it on for about one minute and verify that it is functioning
perfectly.
21