Introduction; Correct Operation - Columbus McKinnon TIGRIP THM 120 Instrucciones De Servicio

11
I
NTRODUCTION
Products of CMCO Industrial Products GmbH have been built in accordance with the state-of-
the-art and generally accepted engineering standards. Nonetheless, incorrect handling when
using the products may cause dangers to life and limb of the user or third parties and/or
damage to the hoist or other property.
The operating personnel must have been instructed before starting work. For this purpose, all
operators must read these operating instructions carefully prior to the initial operation.
These operating instructions are intended to acquaint the user with the product and enable
him to use it to the full extent of its intended capabilities. The operating instructions contain
important information on how to operate the product in a safe, correct and economic way.
Acting in accordance with these instructions helps to avoid dangers, reduce repair costs and
downtimes and to increase the reliability and lifetime of the product. The instructions must
always be available at the place where the product is operated. Apart from the operating
instructions and the accident prevention act valid for the respective country and area where
the product is used, the commonly accepted regulations for safe and professional work must
also be adhered to.
The personnel responsible for operation, maintenance or repair of the product must read,
understand and follow these operating instructions.
The indicated protective measures will only provide the necessary safety, if the product is
operated correctly and installed and/or maintained according to the instructions. The operating
company is committed to ensure safe and trouble-free operation of the product.
C O
ORRECT PERATION
The load lifting attachment is exclusively used for safe manual, horizontal and vertical
transport of steel sheets, lifting plates from stacks, pulling steel sheets out of racks as well as
transporting flat parts of magnetisable steel.
Any different or exceeding use is considered incorrect. Columbus McKinnon Industrial
Products GmbH will not accept any liability for damage resulting from such use. The risk is
borne by the user/operating company alone.
The load lifting attachment is suitable for plate thicknesses of 1 – 5 mm. It is maintenance-free
and features a magnet force without time limit.
The load capacity indicated on the unit is the maximum working load limit (WLL) that may be
attached.
Do not allow personnel to stay or pass under a suspended load.
A lifted or clamped load must not be left unattended or remain lifted or clamped for a longer
period of time.
The operator may start moving the load only after it has been attached correctly and all
persons are clear of the danger zone.
Prior to operation of the load lifting attachment in special atmospheres (high humidity, salty,
caustic, alkaline) or handling hazardous goods (e.g. molten compounds, radioactive materials)
consult the manufacturer for advice.
The load lifting attachment may be used at ambient temperatures between –10 °C and +60 °C
and at a max. air humidity of 80%. In this case the temperature of the load must not exceed
+60 °C, since metals lose their magnetic properties at higher temperatures. Consult the
manufacturer in the case of extreme working conditions.
If longer sheets of metal or profiles are to be transported, we recommend that two or more
load lifting attachments be used.
Always transport the load slowly, carefully and close to the ground.
For handling loads, the limit ranges for manual lifting and carrying of loads by a person must
be observed.
In the case of malfunctions, stop using the load lifting attachment immediately.
©
2016 Columbus McKinnon Industrial Products GmbH