Controls; Refrigerator And Freezer Controls; Setting Controls - Sears Kenmore 69272 Manual De Uso Y Cuidado

Controls
Procedure
1. Remove plastic cap from water valve inlet port.
%
Water valve
% inlet port
Plastic
cap
2. Place brass nut and brass sleeve on copper tubing
(Brass nut and sleeve are found in your literature
packet.) Insert copper tubing into water valve inlet
port. Connect brass nut on copper tubing to water
valve inlet port. Make sure copper tubing is secure by
pulling on copper tubing.
_i'P" clamp
_-Copper
tubing
Water valve /
inlet port
3.
4.
Turn on water supply to refrigerator and check for
leaks. Correct any leaks at connection. Be careful not
to overtighten connection.
Create a service loop using extreme care to avoid
kinks. Secure copper tubing to refrigerator cabinet
with a "P" clamp. It is important to secure copper
tubing to refrigerator to avoid leaks when pushing
refrigerator back into opening.
This refrigerator is designed to operate at normal
household temperatures of 55 ° to 110°F (13 ° to 43°C).
Refrigerator and Freezer Controls
Refrigerator control is located on upper rear wall of
refrigerator section.
4
3 5
2"QI 6
Freezer control is located on left front ceiling of freezer
section.
Freezer
4
Control
IIIIII
Setting Controls
When freezer control is set to OFF, neither refrigerator
nor freezer sections will cool. Initially, set both controls
to 4. Wait 24 hours for refrigerator and freezer sections
to stabilize temperatures. After 24 hours, adjust controls,
one number at a time, as desired. 1 is warmest setting
and 7 is coldest.
Set controls precisely using a household thermometer
with a temperature range between -5 ° to 50°F
(-21 ° to 10°C).
Put thermometer snugly between frozen packages in
freezer section. Wait 5-8 hours. If freezer temperature is
not 0 ° to 2°F (-17 ° to -16°C), adjust freezer control 1
number at a time. Check again after 5-8 hours.
Put thermometer in a glass of water in middle of
refrigerator section. Wait 5-8 hours. If refrigerator
temperature is not 38 ° to 40°F (3 ° to 4°C), adjust
refrigerator control 1 number at a time. Check again after
5-8 hours.