Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CABINET ASSEMBLY

NOTE: The cabinet and suspension have a 70 lb.
weight capacity.
1. Open the cabinet (8) door. Using a 7/16" wrench
and Phillips screwdriver, remove adjustable shelf by
unscrewing four screws.
ATTACHING TO NON-STEEL TOP
1.
Using cabinet as a template, mark location of four
holes for wood screws onto underside of tabletop.
(Recommendation: 1/2" offset from front of table top).
2. Using 5/32" drill bit, drill holes into table top, drilling
about 1/2" to 3/4" deep.
3. Secure cabinet to underside of top, using four
#14-3/4" hex slotted wood screws. (See Figure 22)
NOTE: Cabinet can be flipped to have right or
left facing door.
4. Reinstall adjustable shelf and close cabinet door.
Figure 22
ATTACHING TO STEEL TOP
NOTE: Mounting channels are included with the
steel top. (See Figure 23) Channels may extend
past the cabinet assembly.
Figure 23
PAGE 9 OF 38
OPTIONAL ACCESSORIES CONTINUED
Mounting Channels
1. On the underside of the table, slide mounting
channels front to back into table flanges. When
channels are aligned, mounting holes should be
approximately 14⁄" apart. Secure each channel
with two 14-20 x 5/8" bolts.
2. Attach the cabinet to the mounting channels using
four 14-20 x 1/2" bolts. (See Figure 24)
NOTE: Cabinet door can be flipped to have
right or left facing door.
Figure 24
3. Close the cabinet door and turn the workstation
right side up. Reinstall adjustable shelf.
LIGHT KIT ASSEMBLY
1.
Line up light brackets (10) with uprights at desired
height.
2. Secure to uprights with four 2" bolts and flange nuts.
(See Figure 25)
Flange
Nut
Bolt
Figure 25
1021 IH-5759

Capítulos

Tabla de contenido
loading

Tabla de contenido