Tabla de contenido
Idiomas disponibles
Idiomas disponibles
L-EXTENSION
NOTE: For steps 1-3, refer to diagram on page 1.
1.
Insert adjustable feet (1) into leg (2) and L-leg (14)
and slide into place at desired height. Insert locking
tabs if desired.
2. Leave legs upside down and space 41" apart.
3. Attach 48" stringer (11) to table legs using center
four holes in back legs. Fasten with eight bolts, lock
washers and nuts.
NOTE: See page 6 for steel top assembly.
L-EXTENSION
1.
Using 17 wood screws, attach L-leg (14) and leg (2)
to the underside of 48" top (12) through pre-drilled
holes. (See Figures 9 and 10)
Leg
Figure 9
Not
pre-drilled
Figure 10
NOTE: For L-Extension and L-Table, five holes
on long end of L-leg will not be pre-drilled. If
desired, pilot holes can be created using a drill
and 3/16" drill bit. Hole should be no deeper
than 3/4".
PAGE 5 OF 38
L-SHAPED WORKSTATION ASSEMBLY
NON-STEEL TOP ASSEMBLY
Front
L-Leg
NOTE: Attach L-leg (14) to left side of stringer for
right side L-table configuration. Attach to right
side of stringer for left side configuration.
4. Place 48" tabletop (12) on a smooth, non-marring
surface with top side facing down.
5. Align assembled frame with the pre-drilled holes on
the bottom side of the top.
2. Set bench assembly upright and recheck all nuts,
bolts, and screws for tightness.
NOTE: Do not lean on table. You may need to
prop up corner without leg until table is fully
assembled.
L-TABLE
1.
Slide L-extension underneath base table on right or
left hand side. Make sure that table corners align
perfectly. (See Figure 11)
2. Using five wood screws, attach L-leg (14) to
underside of base table top (5). (See Figure 11)
Not
pre-drilled
Figure 11
1021 IH-5759
Capítulos
Tabla de contenido
