Trust SECURITY PLUS-LINE ALMST-2000 Manual Del Usuario página 7

ALMST-2000 WIRELESS MAGNETIC SENSOR
EN
1. Place batteries
Push with a sharp object on top of the magnetic sensor and pull off the backside. Insert two 1,5V AAA
Alkaline batteries in the slot. Observe the correct polarity of the batteries (place plus and minus on the
correct side).
2. LED indicator
The magnetic sensor has a LED indicator in the housing. The LED behaviour is as followed.
Low battery: LED will blink 3x every 6 sec
Confirm pair: LED will blink 5x
Confirm unpair: LED will blink 5x
3. Pair the ALMST
Consult the manual of the Siren to activate the learn mode. Send (while the learn mode of the Siren is
active) a pair-signal by pressing the SET button for 2 seconds with a sharp object next to the battery
slot of the magnetic sensor. The LED indicator will flash 5x to confirm that the pairing has been done
successfully.
4. Mount the ALMST
Place the magnetic sensor on the window or door and make sure that both points on the two parts
are in line with each other. Mark the top and bottom of both parts. After marking the positions remove
the sensor.
5. Remove backplate from the ALMST
Open the magnetic sensor by pushing with a sharp object on top of both parts and pull off the
backplate.
6. Fasten the ALMST
Screw or tape both backplates of the magnetic sensor on the window or door according to the made
markings. When securing the backplates make sure both parts are mounted with as little space
between as possible (max. 5mm).
1