Blaupunkt Velocity Serie Manual Del Usuario página 13

следует настроить так, чтобы верхние басы звучали
максимально контрастно. Затем снова продолжайте
настройку согласно пункта 2).
Инструкция по установке и подключению
Внимание! Опасность несчастного случая!
Устройство GTb 1200 Mk II нельзя устанавливать на за-
дних полках, задних сиденьях или других открытых вперед
местах. Фирма Blaupunkt рекомендует выполнять монтаж
в багажнике.
Пример подключения (смотри рис. 1).
Утилизация и переработка
Для утилизации старой аппаратуры воспользуйтесь
доступными пунктами приема и сбора вторсырья.
Право на внесение изменений сохраняется
USA
General
Please read these operating instructions before
using the equipment for the fi rst time.
We provide a manufacturer guarantee for our products bought
within the United States of Amerika. The warranty terms can
be called up under www.blaupunktusa.com or requested
directly from:
Blaupunkt USA
2800 South 25th Av.
Broadview, IL 60155
PH: 800-950-2528
FX: 708-865-5296
EM: [email protected]
Safety Notes
Installation and installation instructions
Disconnect the negative terminal of the battery before
carrying out installation and connection work.
Observe the vehicle manufacturer's safety instructions
(regarding airbags, alarm systems, trip computers, ve-
hicle immobilisers).
Prior to drilling the mounting holes, make sure that no cables
and parts of the vehicle will be damaged.
Leave ample clearance between the cables and other har-
nesses. Use the enclosed cable ducts at sharp-edged holes.
Note:
We recommend that you operate the Vb 800/1000 in conjunc-
tion with our Velocity series amplifi ers.
The Vb 800/1000 can be operated in normal as well as in
bridged mode (for further details, please refer to the operating
instructions that came with the amplifi er). In any case, please
observe the RMS output power of your amplifi er. It must not
exceed the RMS power of the Vb 800/1000. Non-compliance
with this can cause damage to the product in the long term.
Setting up the subwoofer tube
In order to achieve a balanced sound, we recommend that you
confi gure the amplifi er as follows.
1. First set the volume control to minimum and the crossover
control to its middle position.
2. Now play some music on your car sound system that you are
very familiar with and that contains some low bass (e.g. pop
music). Now slowly increase the volume of the subwoofer
until you feel that the sound of the music is well balanced,
i.e. the bass is neither too weak nor overpowering.
3. Now listen to the relationship between deep male voices
and the upper bass and also take note of the relationship
between the upper bass (kick bass) and the lower bass.
The bass should ideally sound crisp and have a clear low
bass component, and male voices should neither sound
too weak nor should they billow out. If you are happy with
the sound then you are already fi nished with the setup
process. If not, continue as described in points 4 and 5.
4. If male voices seem to billow out or the low bass is too
weak, you should turn the crossover control slightly to-
wards minimum and then resume making your adjust-
ments as described in point 2 onwards.
5. If the bass sounds low but dirty and booming or the male
voices sound too weak, you should turn the crossover con-
trol slightly towards maximum. Furthermore, you should
set the phase control (if present) so that the upper bass
sounds as powerful as possible. Next, resume making your
adjustments as described in point 2 onwards.
Installation and connecting instructions
Warning! Accident risk!
Do not mount the Vb 800/1000 on the rear
shelf, rear seat or at any position which ist
open towards the front. Blaupunkt recom-
mends to install the system in the boot. Ex-
ample connection (see Fig. 1).
Recycling and disposal
To dispose of the product, please use the available
waste return and collection systems.
Subject to changes!
Vb 800/1000
13