Weidmuller V-Test Instrucciones De Operación página 31

If the pluggable module is not in the data base of the V-Test, type in the values (see 6.2.2.1 Install Module)
This menu will start automatically when the part number is not installed. After the values are stored, the test
runs and each part will be tested and shown in the display.
1171340000/04/08.16
To start the menu measurement it has to be selected with [OK].
Next, the 10 digit order number (product number) must be typed in.
This number can be found on the top side of the pluggable module, see
figure 3. The test will run by pressing [OK].
Testing the Gas Discharge Tube (GDT)
Testing the Voltage Dependent Resistor (VDR)
Testing the Transient Voltage Suppression (TVS) diode
Measurement results "Okay":
Values "Okay"  Product re-usable
Measurement results "Not Okay":
Values "Not Okay"  Replace product
31