Dometic CAM 44 Instrucciones De Montaje página 21

CAM44
Observe the following installation instructions:
• Fix the camera at a height of at least two metres for an adequate view.
Make sure that you have a firm place from which to work when installing the
camera.
• Make sure that the installation location of the camera is sufficiently firm (e. g. to
prevent the camera from being knocked down by branches that may brush the
roof of the vehicle).
• Mount the camera horizontally and in the middle of the rear of the vehicle
(fig. d, page 7).
• Always use the supplied insulation pad (fig. 8 5, page 5). This prevents residual
current caused by a poor earth connections in the vehicle. Residual current can
cause lines of interference in the picture or buzzing in the loudspeakers or even
damage components.
• The most secure type of attachment is with screws fitted through the body.
Please observe the following instructions:
– There must be sufficient space behind the chosen installation location to be
able to carry out the mounting procedure.
– Suitable measures must be taken to prevent water penetrating through any
holes made (e.g. by using screws and sealant and/or spraying the outer
attachment parts with a sealant).
– The location on the body where you wish to attach the camera must be rigid
enough to allow the camera to be tightly fastened.
• Check beforehand that there is sufficient space on the other side for the drill head
to come out (fig. 2, page 4).
• If you are not sure about the location you have chosen, ask your vehicle manufac-
turer or dealer.
I
NOTE
We recommend greasing the threads of the screws to prevent
corrosion.
To perform the installation, proceed as follows:
➤ Hold the camera holder at the chosen location and mark at least two different
points for the drill holes (fig. e, page 7).
➤ Using a hammer and centre punch, gently pre-punch the previously marked
points to prevent the drill head from slipping off.
EN
Fitting the camera
21