F.Bertazzoni F60CONXE Hoja De Características página 22

INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
My accessories and shelf
supports are damaged.
The enamel colour has
changed or stains have
appeared.
A flashing symbol
appears on the temperature
display (2) and an alarm
sounds.
I have programmed the
pyrolytic function, the oven is
working properly but indicator
light (3) is not lit up.
The pyrolytic programme has
finished but the oven door is
locked.
A flashing symbol E:1
appears on the temperature
display (2) and an alarm
sounds. The oven has
stopped heating up.
22
1 2 3 4
You have not removed the
accessories and supports
during the pyrolytic cleaning
cycle.
The chemical composition
of some foodstuffs may cause
changes in the enamel.
The oven is programmed
to carry out a pyrolytic
cleaning cycle but the door is
open.
Indicator light (3) does not
work properly.
The oven has not cooled
down to the safe
temperature.
The oven door has not been
locked. The door is not closed
properly and cannot be
locked.
5 6 7 8 9
12
CAUSE
11 10
SOLUTION
You must replace them and
remove them in later cleaning
cycles.
This is normal and does not
damage the properties of the
enamel.
Close the door to enable the
function to be carried out.
Call the Technical Assistance
Service.
Wait until the oven cools
down and indicator light (3)
turns off.
Touch any sensor to stop the
alarm. Check the door and
make sure that it is closed
properly.