Idiomas disponibles
Idiomas disponibles
Wearing the headset
wearing by earloop
adjust the earloop
wearing on left ear
Charging the headset
Before using the headset for the fi rst time, charge the headset with
the supplied power supply unit for at least 3 hours.
• Connect the included charger to the charging socket on the
headset.
• The integrated LED lights red during the charging process.
The LED goes off when the headset's rechargeable battery is
fully charged.
• Please note that charging may not begin immediately if the
headset has not been used for an extended period of time.
• If the headset has not been used for an extended period of
time, it can take a few minutes after plugging in the power
10
wearing by silicon
rubber hlder
wearing on right ear
supply unit before headset begins to charge. Likewise, during
this time, the LED also does not signal that charging has
begun. Wait a few minutes, and the LED will light up to signal
that charging has started.
Switching the headset on/off
• Press and hold the "MFB" button for 3 seconds to switch on
the headset. The blue LED on the headset then fl ashes.
• Press the "MFB" button likewise for 5 seconds to switch off
the headset. The red LED on the headset fl ashes red briefl y,
and the headset shuts off.
Adjusting the headset to your mobile phone (pairing)
You must "introduce" both components to enable the headset to
communicate with your telephone. This process is known as "pai-
ring" or "coupling" and is the basis for using the Bluetooth headset.
Pairing only has to be carried out once – before the headset is used
for the fi rst time. Ensure that the headset is fully charged and the
power supply unit is not plugged into the headset. Prepare your
telephone for the pairing process. Follow the instructions in your
mobile phone's operating instructions to switch your telephone to
Bluetooth mode and initiate and perform the pairing process.
• Ensure that the headset is switched off.
• Press the "MFB" button on the headset for at least 7 seconds
until the LED starts fl ashing red and blue alternately. The headset
is now in pairing mode. Please note: The headset stays in pairing
mode for about 1 minute. After this time, it must be started again
as described above.
11
