Chicco 06626 Manual De Instrucciones página 41

The Absence of or loss of link
parent with Baby unit.
unit (re- - The voice activation func-
ceiver) tion has been selected.
display - The parent unit (receiver)
does not may be off.
show
any
image
(black
screen)
Image - Too much display bright-
colours ness.
on the
display
are very
light
Image - Too little display bright-
colours ness.
on the - Night vision activated.
display
are very
dark
Interfer- - In rare cases, even if
ence HOPPING technology en-
sures high immunity to in-
terference from analogue
devices, interference can
be caused by the presence
of another intercom or
similar transmission device
switched on nearby or by
electromagnetic pollution
(proximity to antennas
with radio transmitters,
high voltage cables, etc.).
- If the display shows the
units closer together and/or relocate the
units themselves in order to reduce the
number of obstacles, metal structures,
reinforced concrete walls, etc. interposed
between them and/or check that the
Baby unit is on.
- If the display shows the
selector is set to ON, the voice activation
function is active.
As soon as sounds present in the Baby
unit environment exceed the threshold
for voice activation, the parent unit will
emit sounds and will display an image of
the baby again in real time.
- Switch on the parent unit (receiver).
- Press the key (15) until you find the
desired level of brightness.
- Press the key (15) until you find the
desired level of brightness.
- Check the lighting conditions of the
room where the Baby unit is located.
If the room is dark or in low light condi-
tions, alteration of image colour on the
display is to be considered normal.
Move away from analogue equipment
and/or leave the area in which it is
located.
41
icon, move
•
icon and