Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
F
SERVICE
Servicing requires extreme care and knowledge and
should be performed only by a quali.ed service technician.
For service we suggest you return the product to your
nearest AUTHORIZED SERVICE CENTER for repair.
When servicing, use only identical replacement parts.
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual.
Save this operator 's manual and review
frequently for continuing safe operation and
instructing others who may use this product.
ELECTRICAL
EXTENSION CORDS
When using a power tool at a considerable distance from
the power source, use an extension cord heavy enough
to carry the current that the tool will draw. An undersized
extension cord will cause a drop in line voltage, resulting
in a loss of power and causing the motor to overheat.
When working with the tool outdoors, use an extension
cord that is designed for outside use.
Before using an extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
WARNING
Keep the extension cord clear of the working
area. Position the cord so that it will not get
caught on lumber, tools or other obstructions
while you are working with a power tool. Failure
to do so can result in serious personal injury.
WARNING
Check extension cords before each use.
If damaged replace immediately. Never use tool
with a damaged cord since touching the
damaged area could cause electrical shock
resulting in serious injury.
ELECTRICAL CONNECTION
This tool is powered by a precision built electric motor.
It should be connected to a power supply that is
230 volts, 50 Hz, AC only (normal household current).
Do not operate this tool on direct current (DC).
A substantial voltage drop will cause a loss of power and
the motor will overheat. If the product does not operate
when plugged into an outlet, double check the power
supply.
E
I
English
P
NL
SPEED AND WIRING
The speed is not constant and decreases under a load or
with lower voltage. For voltage, the wiring in a shop is as
important as the motor's horsepower rating. A line intended
only for lights cannot properly carry a power tool motor.
Wire that is heavy enough for a short distance will be too
light for a greater distance. A line that can support one
power tool may not be able to support two or three tools.
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding
provides a path of least resistance for electric current to
reduce the risk of electric shock. This tool is equipped with
an electric cord having an equipment-grounding conductor
and a grounding plug. The plug must be plugged into a
matching outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug provided. If it will not fit the outlet,
have the proper outlet installed by a qualified electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface that is
green with or without yellow stripes is the equipment-
grounding conductor. If repair or replacement of the
electric cord or plug is necessary, do not connect the
equipment-grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if
the grounding instructions are not completely understood,
or if in doubt as to whether the tool is properly grounded.
Repair or replace a damaged or worn cord immediately.
PRODUCT SPECIFICATIONS
Hydraulic Cylinder Pressure
Force
Oil Capacity
Voltage
In Put Power
No Load Speed
Noise Level
Net Weight
Log Capacity Diameter, maximum
Log Capacity Diameter, minimum
Log Capacity Length
DESCRIPTION
1.
Bleed screw
2.
Hydraulic control lever
3.
Ram
4.
Oil drain bolt with dipstick
15
FIN
GR
13~16 MPa
4 tons
3.5 L
230 V~50 Hz
1500 W
2970±10% rpm
85 dB
45 Kg
250 mm
100 mm
520 mm
TR
Tabla de contenido
