Working Instructions - Monti BLASTER Manual Del Usuario

EN Operating instructions
7.3

Working instructions

F
F
8. Cleaning
To clean the motor, hold the tool firmly
slots regularly and thoroughly, FIGURE 2.
9. Troubleshooting
Mains powered machines:
•
Overload protection: There is a MAJOR reduction in load speed.
high! Allow the machine to run at idle speed until it has cooled down.
• Overload protection: There is a SLIGHT reduction in load speed.
Reduce the load before continuing to work.
• S-automatic safety shutdown: The machine was SWITCHED OFF automatically.
If the slew rate of the current is too high (for example, if the machine suddenly seizes or
kickback occurs), the machine switches off. Release the Safety Switch to switch off the
machine. Switch it on again and continue to work as normal.
12
Press down lightly on the machine and
move over the surface by making oscillating
movements.
Correct direction of operation.
Less contact pressure = longer service life and
higher performance.
Note that excessive pressure will lead to
damaging the Bristle Blaster
breakage of the tooth belt.
and blow compressed air through the rear ventilation
®
BRISTLE BLASTER ELECTRIC DOUBLE
®
Belt and even
The motor temperature is too
The tool is overloaded.