Trust START-LINE AWST-6000 Manual Del Usuario página 7

AWST-6000 WIRELESS MOTION SENSOR
EN
1. Open the motion sensor
Use a thin screwdriver to detach the sensor from the frame.
2. Install transmitter batteries
Place 2x 1,5V AAA alkaline batteries in the battery compartments.
The polarity should match the symbols on the holder.
3. Assign code to a Trust SmartHome receiver
Assign this transmitter to the memory of one or multiple receivers, by sliding the LEARN switch from
[DEL] to [SET] to send an ON-signal. Read the receiver's manual for the code learning procedure.
4. Set light sensitivity
Slide the [R] switch to select 1 of the 3 light sensitivity levels. [H]: Sensor is always active. [M]: Sensor is
active when the environment brightness is less than 20 lux (late afternoon). [L]: Sensor is active when
the environment brightness is less than 10 lux (late evening). If you want to control chime
ACDB-6500C, always choose [H].
5. Set switch-off delay
When no more motion is detected, the transmitter automatically sends an OFF-signal after 5 seconds
or 1/5/10 minutes.
6. Set detection range
Slide the [ ] switch to select 1 of the 3 detection ranges.
[1M]: 1-3 meters
[3M]: 1-5 meters
[6M]: 1-7 meters
1