Idiomas disponibles
Idiomas disponibles
29. Grasp the TIPM (1) and rotate the assembly up to free
it from its mounting bracket (3). Position the assem
bly upside down to access the electrical connectors
located on the bottom of the unit.
30. Cut the tailgate power lock harness to length.
31. Disconnect connector C5, letter "E" labeled on the bottom of the TIPM. Release by depressing the locking tab and
rotating the connector arm outboard, until the connector is free from the TIPM assembly (1). Be certain to pull the
connector straight off.
32. Cut the P34 circuit TN/LB from cavity 18 (Right Rear Door Unlock Driver), using steps 38 through 43 solder in the
W/P tailgate wire.
33. Cut the P38 circuit TN/DB from cavity 22 (Right Rear Door Lock Driver), using steps 38 through 43 solder in the
BK/DB tailgate wire.
Dec 01, 2011
2009 2010 RAM 1500
9
K6869568 Rev. 3
