Idiomas disponibles
Idiomas disponibles
38. Cut each wire and remove 13mm (0.5 in.) of insulation
from each wire that needs to be soldered/spliced.
CAUTION: Do not use acid core solder.
39. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol
dered area.
40. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
41. Using crimping tool (1), Mopar® p/n 05019912AA or
equivalent, crimp the splice clip and wires together.
42. Solder (3) the connection (2) together using rosin core
solder (1).
43. Center the heat shrink tubing (2) over the solder joint
and heat using a heat gun. Heat the joint until the tub
ing is tightly sealed and sealant (1) comes out of both
ends of the tubing.
44. Secure the power lock actuator harness to the TIPM
harness.
Dec 01, 2011
11
K6869568 Rev. 3
