Before Using For The First Time; Button Function; Manual Operation - Russell Hobbs 28241-56 Manual De Instrucciones

BEFORE USING FOR THE FIRST TIME

Turn to "CARE AND MAINTENANCE" and clean the appliance, to remove manufacturing dust, etc.
PREPARATION
1. Sit the motor unit on a stable, level surface.
2. Lower the jug on to the motor unit. You cannot operate your blender unless the jug is correctly
placed onto the motor unit. This is a safety feature.
3. Remove the lid.
4. Put the ingredients into the jug. Don't fill past the 1500 ml mark. If you do, the contents may force the
lid off when you start the motor.
5. Replace the lid. Don't operate the appliance without fitting the lid.
6. Put the plug into the power socket.
CONTROLS
When you connect your blender to the mains supply, the control panel will show the C symbol to indicate
that it is in standby mode. Tap C to activate the control panel. The control panel is a touch screen. After 30
seconds of inactivity, your blender will revert back to the standby state.
The following table lists the controls and gives a brief overview of their function.
Button Function
Standby. Tap to switch your blender in or out of standby mode.
C
Stop. Tap to stop blending, or to stop the currently active program.
@
Start. Tap to start blending, or to start the selected program.
+
Slider control. Swipe left or right to select or modify the speed. Tapping the slider
control along its length will move the speed control to the point where you tap.
+
Highest speed. Tap to set the speed control to its maximum setting.
–
Lowest speed. Tap to set the speed control to its minimum setting.
*
Ice crush/Pulse - for crushing ice or fine blending control.
%
Smoothie - blend frozen fruits and other ingredients into thick smoothies.
^
Icy drink - liquefy frozen drinks.
&
Soup - use for making soups.

MANUAL OPERATION

You can start, stop, pulse and choose the speed of your blender manually to suit the ingredients you are
processing.
1. Tap C to activate the control panel.
2. Swipe or tap the slider control to the desired speed.
3. Tap the flashing + icon to start your blender. Your blender will start at the selected speed.
• To stop blending, tap @ at any time.
• To change the speed, swipe or tap the slider control at any time. Tapping + will change to full speed;
tapping – will change the speed to minimum.
• When you have finished, tap
before removing the lid from the jug, or removing the jug from the motor unit.
C
then unplug the blender. Always wait till the blades come to a stop
4