System Shutdown; Camera Viewing; To Change The Cameras To Be Viewed - Dedicated Micros D4 Guía De Programación

System Shutdown

If the D4 needs to be switched off for any reason, the shutdown procedure needs
to be followed:
1. Select 'Enabled' in the System Shutdown option.
2. When the pop-up menu appears, press and hold camera 1 for five seconds to
shutdown.
3. The message 'It is now safe to switch off your unit' is displayed, switch the D4
off at the wall.
WARNING: Data loss or disk failure may occur if a system shutdown is not
performed before removing power.
DST
Daylight saving time can be adjusted automatically or manually. By default, the
automatic setting will go forward one hour on the last Sunday in March at 01:00,
and one hour back last Sunday in October at 02:00. The default automatic
settings can be changed. If the country where the unit is located doe not use DST
then select manual.

Camera Viewing

An option is available to view all cameras or selected cameras. All the cameras are
viewed by default. Cameras removed from viewing do not affect the cameras
being recorded.

To change the cameras to be viewed

• Press the ' ' cursor key to change the edit field to 'Selected cameras'.
• A menu will display the cameras to be viewed.
• Press the camera key to toggle the camera in or out of the viewed sequence.
This camera will be displayed. A filled box denotes cameras that can be viewed.
Note: Cameras removed from view are not displayed on the main or spot monitor
in live or playback mode, multiscreen displays will show a blank segment.
Tip: It is advisable to set a password to stop this setting being altered by
unauthorised personnel.
11