Initial Operation - Bosch WEU UniversalInspect Manual Original

OBJ_BUCH-3040-001.book Page 22 Monday, February 6, 2017 8:23 AM
22 | English
Attaching the mirror, hook or magnet (see figures A and B)
The mirror 22, hook 23 or magnet 25 accessories can be attached to the camera head
10.
Hook the mirror 22 or hook 23 into one of the two holes 9 on the camera head 10 and
fit the sleeve 24 for attaching the accessory (see image A).
Push the magnet 25 into the sleeve 24 and hook it into one of the two holes 9 on the
camera head 10. Fit the sleeve 24 for attaching the accessory (see image B).
Note: The magnet 25 and the hook 23 are only suitable for moving and removing
loose, small and light objects. Applying too much tension can damage the inspection
camera or the auxiliary aid.
Operation
 Protect the inspection camera against moisture and direct sunlight. The cam-
era cable and camera head are waterproof. However, the inspection camera's
housing is not protected against water. If it comes into contact with water, there is
a risk of electric shock or damage.
 Do not subject the inspection camera to extreme temperatures or variations
in temperature. As an example, do not leave it in vehicles for longer periods. In
case of large variations in temperature, allow the inspection camera to adjust to
the ambient temperature before putting it into operation.
 Do not use the inspection camera when the lens on the camera head 10 is
misty or fogged-up. Do not switch the inspection camera on until after the
moisture has evaporated. Otherwise, the inspection camera can become dam-
aged.
 The switched-on illumination light 11 can become hot during operation. In or-
der to prevent burns, do not touch the illumination light.

Initial Operation

Switching On and Off
To switch on the inspection camera, press the on/off button 4. Photo mode 13 ap-
pears on the display 7 (magnification 1.0 and illumination 50 %).
To switch off the inspection camera, press and hold the on/off button 4 for more than
3 seconds.
If no button is pressed on the inspection camera, it switches off automatically after
approx. 20 minutes.
1 609 92A 3HR | (6.2.17) Bosch Power Tools