Evers FX-HV Serie Manual De Instrucciones página 20

6. Lift the system slowly a few centimeters
and check on Device if the load is securely
held. Always keep enough distance and
make sure that the Extension Arm does not
swivel abruptly about 90°. Make sure that
the hoist moves in the pivot axis through the
respective center of gravity
8. Put the load on a suitable underground,
swing the load slowly in the horizontal posi-
tion and make sure that the hoist moves in
the pivot axis through the respective center
of gravity.
Turn OFF the magnet when the load is
secured on a stable underground.
7. Proceed further to the Vertical, make sure
that the load can not slip, e.g. over the edge
of a pallet or a table edge.
Then lift the load completely in the balance,
make sure that the load is not swinging and
then transport the Load
9. Change your hoist from the Vertical eyelet
to the Horizontal eyelet and remove your HV
System from the Workpiece
19