Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. To switch between the two types of buns per
your stop block setting, locate the selector lever
on the front of the toaster frame. Move the lever
left or right to switch back and forth between the
combination setting. See figure 14.
figure 14
SELECTOR
LEVER
BUN BOARD ADJUSTMENTS
1. Push or pull the bun board handle to desired
notched setting as indicated by graphics
stamped on top of bun board. See figure 15.
2. Bun board graphics are:
FRONT = REG, RYE, QTR HEELS
REAR = BIG MAC, (CROWNS) AND RIB HEELS
TROUBLESHOOTING GUIDE
PROBLEM
Platen loose.
Speaker sounds, but no
bun done light comes on.
No audio alarm or
amber colored bun
"done" light.
Buns being crushed.
Platen does not heat.
No Display.
figure 15
CLEANING
FRONT OF
FRAME
1. Press the power switch to the off position.
2. Unplug toaster.
3. Allow toaster and platens to cool down.
4. Wipe entire platen with clean, damp grill cloth.
Full toaster cleaning must be done in the morn-
ing when toaster is cold. See your Planned
Maintenance Card for proper cleaning procedures.
IMPORTANT: Do not drape cord over hot toaster bun
board or platen. This will cause cord to burn.
CAUSE
Platen bolts loose.
Done light burned out.
Interconnect cable connection
loose.
Keyhole slot filled with debris.
Speaker defective
Opto-Sensor board defective
Stop blocks not adjusted
properly.
Warped bun trays.
Buns cut improperly.
No power.
Power switch defective.
Shorted power board.
Platen burned out or shorted.
Fuse Defective.
8
SOLUTION
Tighten platen bolts.
Replace done light.
Check connections at Opto-Sensor
board and main board.
Clean keyhole slot.
Replace speaker.
Replace Opto-Sensor board.
Adjust stop blocks.
Straighten or replace bun
trays.
Contact bakery.
Check power source.
Replace power switch.
Replace power board.
Check platen with ohmmeter
for 11 ohms, if reading is less
than 7 ohms or more than 14
ohms, replace platen.
Check fuse with ohmmeter,
reading should be 1-2 ohms.
Tabla de contenido
