Hoover XARION Manual Del Usuario página 7

Cleaning the cylonic unit
If necessary the cyclone unit can be removed from the cyclonic cassette and cleaned.
1. Remove dust container from the cleaner by releasing the container carry handle to
detach the dust container from the main cleaner and pull upward to remove. [8,9]
2. Place the bin on a flat surface and unclip the clips from either side of the dust con-
tainer. [16]
3. Using the bin handle lift the bin upper section containing the cyclonic unit from the
lower section. [17]
4. Use a cloth to remove excessive dust from the cyclone unit's surface.
5. Reassemble the bin upper section taking care to align the arrows on the container.
Push clips back to fully close the bin. [19]
6. Refit the dustbin to the cleaner. To lock in place push the container carry handle
down until the latch connects with the main body of the cleaner. Once correctly re-
tained the carry handle will sits flush with the top of the cleaner.
Removing a blockage
1. Check if the dust container is full. If so refer to 'Emptying the dust container.
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so refer to 'Cleaning the washable filters'.
B. Check if there is any other blockage in the system - Use a rod or pole to remove
any blockage from the extension tube or flexible hose.
C. Check if pre-motor filter is fitted and filter door is closed
D. Check if the cyclonic unit needs to be cleaned. Refer to 'Cleaning the cyclone
unit'
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the cyclonic dust container over-filled? Please refer to 'Cleaner Maintenance'.
• Is the filter blocked? Please refer to 'Cleaner Maintenance'.
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the
system'.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to auto-
matically reset.
0565-5312 Xarion IM ML.indd 7
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your lo-
cal Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
• Hepa / Micro Filter pack: U46 - 35600814
• Carpet & Floor Nozzle: G72 - 04845090
• Allergen Remover Turbo Nozzle: J31 - 35600816
[18]
• Allergen Remover Mini Turbo Nozzle: J32 - 35600817
• Flexible Hose: D101 - 35600815
• Caresse Nozzle: G90PC - 35600660
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Quality, Safety and the Environment
Safety
Although safety certification of electrical appliances is not required by law in the UK, Hoo-
ver believe that independent approval is the best way of demonstrating safety in design
and manufacture. The British Electrotechnical Approvals Board (BEAB), the independent
UK national authority for the safety of domestic electrical appliances, ensures that Euro-
pean safety standards are met and maintained throughout the production life of an appli-
ance. All appliances that pass the requirements are permitted to carry the BEAB mark of
safety.
Quality
BSI ISO 9001
Hoover's factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001
7
GB
09/05/2008 12:15:25