sauermann SI1800SCUN23 Manual Del Usuario página 9

d/ Installation / Settings
The SI 1800 or Si-82 pump must be installed horizontally either on the ground (Fig.6), on a wall (262
mm drilling template supplied on P.3) or hanging from the ceiling (Fig. 4), using the fixed slot holes on
the casing (to hang the pump from the ceiling it is necessary to use 4 threaded rods + nuts as well as
the drilling templates shown on P.3). It is possible to choose the side of the water exit (Fig.7). Reversible
pump block (Fig. 12).To
ensure proper ventilation of the motor, the pump must be free of any obstruction. Be careful not to bend
the flexible discharge tubing (Fig. 8). A reinforced tube can be used. For the reduction in flow due to
pressure loss, consult the flow chart (Fig.3).
2/ USE
NB: The float protection system (red tag) inside the pump must be removed before the unit is
operated (Fig. 12). Please remove pat before use.
a/ Operation
Pour water into the pump. Check that the pump starts and stops once the water level begins to fall. To
check the high level alarm operation, continue to pour water into the pump until the alarm contact switch
is set OFF (use a testing meter).
b/ Cleaning.
NB: The pump must be disconnected from the mains power supply before any maintenance work is
carried out.
The inside of the pump should be cleaned regularly. Remove the tank and clean it with a mild cleaning
solution (such as water with 5% bleach). At the same time, check that the float is clean and free of foreign
matter. Re-install the tank and re-check the operation, including the start, stop and alarm.
3/ SAFETY
- The alarm contact will prevent condensate overflow (cut out of compressor demand).
- Thermal overload protection (integrated into the pump): cut out at 105°C.
- Fire rated plastic enclosure.
4/ WARRANTY
24 months warranty from the date of delivery. This warranty covers all parts or materials with manufactu-
rer's defects and is limited only to the replacement or repair of defective parts. No claims can be made for
labour costs or indirect damages. Defective pumps must be returned complete. They will then be checked
by the manufacturer pending a report on the replacement of the defective part if necessary. We decline
all responsibility if the unit is not installed or maintained according to our standards and specifications or if
the alarm safety contact is not used.
RECOMMENDED DACCESSORIES
ACC00125
ACC00126
ACC00801
ACC02040
ACC00215
PVC hose Ø 10mm int, 25 m long
Reenforced PVC hose Ø 10mm int, 25 m long
Replacement check valve. For Ø10 mm int. tube.
Rubber condensate outlet adaptor Ø 24-25 - 32 - 40 mm
Condensate self-sealing evacuation connectors, Ø 10 mm int.
9