Further Safety Directions - Deltafox DP-EIW 4533 Traducción Del Manual De Instrucciones Original

4) USE AND TREATMENT OF
POWER TOOLS
a) Do not force the power tool. Use
the correct power tool for your ap-
plication. The correct power tool will
do the job better and safer at the rate
for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and off.
Any power tool that cannot be con-
trolled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any ad-
just -ments, changing accessories,
or storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
d) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are dan-
gerous in the hands of untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less Iikely to
bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result in
a hazardous situation.
h) Hold the device by the insulated grip-
ping surfaces when performing work
in which the cutting tool may come
into contact with hidden wiring or its
own cord. Contact with a live wire can
also cause a charge in metal parts of the
device and result in an electric shock.
h) Keep handles dry, clean and free
from oil and grease. Slippery handles
and handle surfaces do not permit safe
operation and control over the power
tool in unexpected situations.
5) SERVICE
Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

Further safety directions

a) Hold the power tool by the insu-
lated handle grips when performing
work in which the screw may come
into contact with hidden wiring or
its own power cord. If the screw
were to come into contact with a live
electrical cable, metal parts of the ap-
pliance could also become live and
cause an electric shock.
b) Keep hands away from rotating
parts. Wait until the power tool has
stopped before placing it down.
Risk of injury!
c) Avoid contact with the tool insert
or the component part immediately
after processing. The parts may be
hot and cause burn injuries.
GB
17