Wesco WS8913K Manual Del Usuario página 10

Read the operator's manual.
The output plug is with positive center pole
and negative outer pole
T 1A
Fuse
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The laser level is intended for determining and checking
horizontal and vertical lines.
ASSEMBLY
1. INSERTING/REPLACING THE BATTERIES (SEE FIG.
A1, A2)
NOTE: Protect the tool against moisture.
To insert, open the battery compartment cover and insert
the battery pack into the battery compartment.
To remove, open the battery compartment cover and take
the battery pack out from the battery compartment.
BEFORE PUT INTO OPERATION
1. CHARGING THE BATTERY PACK
WARNING: The charger and battery pack are
specifically designed to work together so do not
attempt to use any other devices.
NOTE: Your battery pack is only partially charged before
shipment and you must fully charge once before use.
Charging procedure (See Fig. B1, B2)
1) Plug charger plug into a suitable power outlet. The light
will illuminate green.
2) Open the soft rubber cover to expose the battery
charging socket. Plug the charger to the laser level
(battery pack should be installed in). The light will turn
to red to indicated the charging process has started.
3) When charging is completed, the light will turn to green.
10
Unplug the charger from the power outlet and then
unplug from the laser level.
CHARGING INDICATOR
Light
Red on
Green on
WARNING! Recharge is not recommended for
more than 24 hours after each use.
WARNING! Do not charge at extremely high
or low temperatures. Do not charge at a
temperature below 0°, otherwise the battery life will be
reduced. The tool and power adapter will heat slightly
when charging.
CAUTION! Please charge and discharge the
battery periodically to extend the service life of
battery when it has not been used for long time.
CAUTION! The battery equipped has been tested
by our strict internal quality control process and
inspection standards. Do not disassemble the battery
or replace with other brands, so as to avoid possible
dangers such as electric shock, explosion and burn.
The battery equipped enjoys the quality assurance.
Any repair or disassemble required on battery should
be performed only by authorized service personnel or
after-sales department.
CAUTION! Some attenuation will happen
normally in the Li-ion battery after long time
working such as two years. Any questions, please
contact local qualified service center or after-sales
department timely.
OPERATION
WARNING: Protect the measuring tool against
moisture and direct sun light.
WARNING: Do not subject the measuring tool to
extreme temperatures or variations in
temperature. As an example, do not leave it in vehicles
for long time. In case of large variations in
temperature, allow the measuring tool to adjust to the
ambient temperature before putting it into operation.
In case of extreme temperatures or variations in
temperature, the accuracy of the measuring tool can
be impaired.
WARNING: Avoid heavy impact or falling of the
measuring tool. After heavy exterior impact on
the measuring tool, an accuracy check should always
Status
Charging
Fully Charged
EN