Conversion To A Different Type Of Gas; Commissioning; Instructions For Use; Reminders For The User - AFG NI74TED Instrucciones Para Instalación, Uso Y Mantenimiento

• Make sure the water circuit is free from ferrous particles befo-
re connecting the filter and the appliance.
• Seal any unused connectors with a plug.
• Once the appliance has been installed, check for leaks at the
connection points.
• Hot water connection: the water temperature must not exceed
60°C.
• The water inlet pressure must be between 150 kPa and 300
kPa. Use a pressure reducer if the inlet pressure is above the
maximum permitted level.
• The appliance is intended to be permanently connected to
the mains water supply and not via disconnectable fittings.
CONNECTION TO THE WATER DRAIN
The water drainage system must be provided using materials
resistant to temperatures of 100 °C. The bottom of the applian-
ce must not be subjected to steam produced by drainage of
hot water. Install a siphoned floor drain with grating below the
water drain cock of Boiling pans and in front of Bratt pans.

12 CONVERSION TO A DIFFERENT TYPE OF GAS

13 COMMISSIONING

See Chapter " INSTRUCTIONS FOR MAINTENANCE".

INSTRUCTIONS FOR USE

REMINDERS FOR THE USER

The manufacturer will not be liable for
any damage or injury resulting from fai-
lure to observe the following rules.
The meaning of symbol
CAUCTION MAGNETICFIELD.
• Read this manual carefully. It provides im-
portant information for safe installation,
use and maintenance of the appliance.
• Keep this manual in a safe place known to
all users so that it can be consulted throu-
ghout the working life of the appliance.
• Installation, conversion to a different type
of gas and appliance maintenance must
be carried out by qualified technicians au-
thorized by the manufacturer, in complian-
ce with current safety standards and the
instructions given in this manual.
• For after-sales service, contact technical
assistance centers authorized by the ma-
nufacturer and demand the use of original
spare parts.
• Have the appliance serviced at least twice
a year. The manufacturer recommends ta-
king out a service contract.
6
• The appliance is designed for professional
use and must be operated by trained per-
sonnel.
• The appliance is to be used for cooking
food as specified in the reminders for use.
Any other use will be considered improper.
• Do not allow the appliance to operate
empty for prolonged periods.
• Do not leave the appliance unattended
while in operation.
• In the event of an appliance fault or mal-
function, shut the gas shut-off valve and/or
switch the appliance off at the main switch
installed upline.
• Clean the appliance following the instruc-
tions given in Chapter " INSTRUCTIONS
FOR CLEANING".
• Do not store flammable materials in close
proximity to the appliance. FIRE HAZARD.
• Do not obstruct any air vents or drains pre-
sent on the appliance.
• Do not tamper with appliance components.
• Do not use the appliance without the fil-
ters.
• Under no circumstances should the induc-
tion cooker be switched on if the glass ce-
is:
ramic hob is cracked or broken. This could
be dangerous.
• With the transmission of heat from pots,
the glass ceramic hob becomes extremely
hot and must therefore never be touched
after cooking (risk of burns).
• Do not place metal items (equipment, kni-
ves, etc.) near the cooking zones, as they
can become hot very quickly.
• During use, take care when wearing rings,
watches and similar items since these can
become extremely hot if too close to the
cooking zone.
• Users must be informed of the potential
risks for individuals fitted with a heart pa-
cemaker or metallic prosthesis.
• The use of personal safety equipment is
recommended - risk of very hot food being
scattered.
• During appliance operation, the floor sur-
rounding the appliance may become slip-