Technical Specifications - KRATOS SAFETY Olympe-S Manual De Instrucciones

manufacturer or to a qualified person appointed by the manufacturer.
Do not remove, add or replace any component of the product.
Chemical products: Put the system out of use if it is exposed to chemical products, solvents or fuels which could affect its operation.

TECHNICAL SPECIFICATIONS:

Usable length (from connector to connector): 1.80 m. Webbing width: 25 mm - Material: polyester. Breaking strength > 15 kN
COMPATIBILITY FOR USE:
The device can be used with a fall arrest system as defined in the product's factsheet (see standard EN363) to guarantee that the dynamic
force exerted on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body support device permitted for
use. It may be dangerous to create your own fall arrest system in which each safety function may interfere with another safety function. As
such, before each use, refer to the recommendations for use for each of the system's components.
INSPECTIONS:
The recommended service life of the equipment is 10 years (in accordance with the annual examination by a competent person authorised
by KRATOS SAFETY) for devices with a cable lanyard or webbing lanyard, but it may be increased or reduced according to use and/or
the results of the annual inspections. The product must always be inspected if there is any doubt or after a fall and at least annually by the
manufacturer or the manufacturer's representative, to ensure it is strong and therefore safe for the end user. The product's factsheet must be
completed (in writing) after each check; the inspection date and the date of the next inspection must be indicated on the factsheet, it is also
advisable to specify the date of the next inspection on the product.
MAINTENANCE AND STORAGE: (these instructions must be strictly observed)
During transportation, keep the equipment away from any cutting edges and in its packaging. Clean with water, wipe with a cloth and hang
in a ventilated room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may
have got wet during use. The device must be stored in a cool, dry and ventilated room, and in its packaging.Allemand
9