Black and Decker GWC54PC Manual Del Usuario página 5

After use
Inspection and repairs
Additional safety instructions for
blowers
When not in use, the appliance should
be stored in a dry, well ventilated place
out of reach of children.
Children should not have access to
stored appliances.
When the appliance is stored or trans-
ported in a vehicle it should be placed
in the boot or restrained to prevent
movement following sudden changes
in speed or direction.
Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts and any other condi-
tions that may affect its operation.
Do not use the appliance if any part is
damaged or defective.
Have any damaged or defective parts
repaired or replaced by an authorised
repair agent.
Never attempt to remove or replace
this manual.
The intended use is described in this
manual. The use of any accessory or
attachment or performance of any opera-
tion with this appliance other than those
recommended in this instruction manual
or damage to property.
To protect your feet and legs while
operating the appliance, always wear
heavy duty footwear and long trousers.
Always switch off your product, allow
the fan to stop and remove the battery
when:
You leave your product unattended.
Clearing a blockage.
u
u
u
u
u
u
u
any parts other than those specified in
can present a risk of personal injury and/
u
u
u
u
Vibration
working on your product.
If the appliance starts to vibrate
abnormally.
Do not place the inlet or outlet of
the vacuum near eyes or ears when
operating. Never blow debris in the
direction of bystanders.
Do not use in the rain or leave out-
doors while it is raining.
Do not cross gravel paths or roads
whilst your product is switched. Walk,
never run.
Do not place your unit down on gravel
while it is switched on.
Always be sure of your footing, particu-
larly on slopes. Do not overreach and
keep your balance at all times.
openings. Never use if the openings
are blocked - keep free of hair, lint,
dust and anything that may reduce the
The declared vibration emission values
stated in the technical data and the
declaration of conformity have been
measured in accordance with a standard
test method provided by EN50636 and
may be used for comparing one tool with
another. The declared vibration emission
value may also be used in a preliminary
assessment of exposure.
Warning! The vibration emission value
during actual use of the power tool can
differ from the declared value depending
on the ways in which the tool is used.
The vibration level may increase above
the level stated.
(Original instructions)
Checking, adjusting, cleaning or
u
u
u
u
u
u
u
Do not place any objects into the
u
airflow.
ENGLISH
5