Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Align the Front Visor on the outside of the door frame.
3
Gently press the exposed areas of tape against the surface and
Apply pressure along all flnges to ensure proper adhesion of tape.
verify position. With the Front Visor in its final position, remove the
remaining tape liner by pulling on free end.
4
5
4 Piece Set
Peel back 2" (5 cm) of tape liner from each end of top flange. Completely remove small tab tape liner.
free end
free end
top flange
front
rear flange
6
small tab
Align the front edge of the visor with the front of the rear door, and slide the rear visor flange BETWEEN the plastic applique and
rubber weatherstrip at the rear location. Align the top of the visor with the top of the door frame.
Rubber Weatherstip
Plastic
Applique
7
Page 2 of 3