Safety And Warnings; Tools Required - Ingersoll Rand UP Serie Instalación Y Funcionamiento

2
INSTALLATION

0.0 SAFETY AND WARNINGS

Refer to (Safety and Warnings) in the compressor Operators /
Instruction Manual.
Shut down the compressor. Close the isolation valve. Relieve the
system air pressure. Ensure that all air pressure has been relieved
from the compressor and air system.
Disconnect power to the compressor before servicing. Lock and
tag the main power disconnect switch in the open (off) position.
HASP
KEY LOCK
FIGURE 0.0–1 MAIN DISCONNECT LOCKED AND TAGGED
1.0 DESCRIPTION
1.1 PURPOSE
The purpose of these instructions is to identify the correct parts
required when installing the Power Outage Restart Option and explain
the operation of the option. If this option is furnished on the compressor
from the factory, use this supplement for operation reference only.

1.2 TOOLS REQUIRED

Only what would be found in any reasonably equipped serviceman's
tool box.
2.0 INSTALLATION
Power Outage Restart Option
To install Power Outage Restart Option, follow steps 1–13.
1. Remove the option module (39194097) from its packaging.
en
2. Insert the module into the option module socket labeled J11 on the
right side of the IntellisysR controller enclosure per figure 2.0–4.
3. Drill a 7/8 inch (22mm) diameter hole in the right side of the starter
enclosure at the location shown in Figure 2.0–1.
4. Press out the knock–out hole in the rear of the horn mounting box.
5. Remove the locknut (39108949) from the hub (35275494) and
mount the hub on the back of the horn mounting box.
6. Install and tighten the hub locknut on the side of the mounting box.
7. Screw nipple (95934279) into the hub.
8. Install the sealing locknut (39108949) on the nipple, with the seal
material away from the horn mounting box and tighten securely.
9. Insert the nipple through the hole in the side of the starter enclosure
and install another locknut on the inside of the starter enclosure with the
seal material facing the side of the starter enclosure. Tighten the
assembly so the horn mounting box is secure.
10.Using the wire supplied in the kit, connect the horn as shown on
the wiring schematic decal.
LEVER
11.Install the .5" NPT plug (39146733) in the hole in the top of the horn
mounting box.
TAG
12.Mount the horn on the horn mounting box that was previously
mounted to the side of the starter enclosure and tighten the retaining
screws.
13.Install the corresponding decal for PORO option on the front of the
starter enclosure door as shown in Figure 2.0–3.
FIGURE 2.0–1 STARTER ENCLOSURE
(WITH HORN MOUNTING HOLE LOCATION)
HOLE LOCATION