Fault Codes; Product Disposal - UFESA TotalChef RK3 Manual De Instrucciones

EN
9. Only wipe the main appliance with a damp soft cloth!
10. If the bowl and blade is hard to clean. You may add some hot soapy water in the bowl and run the
appliance at speed 1 for few seconds.
11. When there is burn mark on blender jug bottom, put some citric acid or lemons into water, heat 5
minutes, and then remove the burn mark with a mop.

FAULT CODES

Code Status
E1 "E1" shows on LCD, and sound
"Beep" will be heard.
E2 "E2" shows on LCD, and sound
"Beep" will be heard.
E3 "E3" shows on LCD, and sound
"Beep" will be heard.
E5 "E5" shows on LCD, and sound
"Beep" will be heard
End "End" shows on LCD, and sound
"Beep" will be heard
RESET TEMPERATURE CONTROL
If the temperature gets over and the jug does not work, please, press the temperature button to reset
temperature control. After cooling the jug, it can work as normally.

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electrical
and electronic waste collection center closest to your home.
36
Solution
Motor overload. Un-plug, cool down the device for
an hour. Afterwards, it is ready for use again.
No weighing sensor was detected or the weighing
sensor is damaged.
The bowl wasn't installed. Install it according to
the operating instruction or NTC is damaged.
There's no water for steamer function. Add water
to rework.
Program end. Press knob and return standby
mode.
Temperature button.
Press it and "Click"