Teac UD-701N Manual Del Usuario página 27

Playing back audio files from a computer
1
Connect the USB port on the back of this unit
to the computer using a USB cable.
o Use a cable with a connector that matches that of this unit.
2
Turn the computer on.
o Confirm that the operating system has started properly.
3
Shift the STANDBY/ON switch to its ON posi-
tion to turn the unit on.
4
Turn the SOURCE knob to select USB.
5
Start playback of an audio file on the computer.
By maximizing the output volume from the computer and
adjusting the volume output from the stereo amplifier, better
sound quality can be achieved.
Minimize the stereo amplifier volume before beginning play-
back. Then, gradually increase it.
When using headphones connected to this unit, turn the
VOLUME knob counterclockwise to minimize the volume before
putting them on. Then, gradually increase it.
o The computer and this unit cannot control each other.
o Do not do any of the following when playing back audio files
over the USB connection. Doing so could cause the computer
to malfunction. Always quit the audio playback software before
conducting any of these operations.
o Unplugging the USB cable
o Turning the unit off or putting it into standby mode
o Changing the current input selection
o Computer operation sounds will also be transmitted when play-
ing back audio files over the USB connection. To avoid outputting
these sounds, make the necessary settings on your computer.
o If you start the audio playback software before connecting this
unit with the computer or before setting the input to USB, audio
files might not play back properly. If this occurs, restart the audio
playback software or restart the computer.
EN
27