Installing The Clamps - Leer PACE EDWARDS ULTRAGROOVE ELECTRIC Instrucciones De Instalación

• Secure the rails to the truck bed by installing two clamp assemblies per rail. Slide the Clamp Grip onto the
Clamp Extension toward the Shim Bracket (FIG 7A and 7B). Then, assemble the rest of the clamp parts
as shown below (FIG 7D).
• Now tighten your clamp bolts with your Torque Wrench to 70 in-lb (5.9 ft-lb). Finally, check for proper spacing
by measuring between the rails by attempting to insert the BR Gauge in between the rail metal and the
handle stop (FIG 7E). You can also check the measurement between the rail at the canister and the tailgate
end of the rails. The measurements should be equal to or less than those in Figure 7C. The Clamp Extensions
have been pre-installed with brackets and shims to achieve the proper Between the Rail dimension (BR)
when placed on an average factory truck bed. However, not all truck beds are average dimensionally and
some have optional plastic caps or over the rail spray-in liners.
FIG. 7A
Handle
Stop
FIG. 7C
7C
FIG. 7C
FIG. 7C
Note: If there's any obstruction with the Pivot Arm, you can move the bracket forward or
FIG. 8A
backward. Torque the clamp bolts to 70 in-lb (5.9 ft-lb).
10
Wing Nut
STEP 7: INSTALLING THE CLAMPS
FIG. 7A
FIG. 7A
FIG. 7A
FIG. 7D
FIG. 7B
FIG. 7B
FIG. 7B
FIG. 7B
Part Number Between Rails (BR)
KE2174
KE2175
Part number is on the serial number label
in the upper left corner of the canister
(looking from tailgate).
FIG. 7D
Short
FIG. 7D
Clamp Grip
FIG. 7D
FIG. 7D
Rail
Rail
Metal
Metal
FIG. 7E
FIG. 7E
59-1/16"
59-1/16"
Short
Clamp Grip
Short
Short
Clamp Grip
Clamp Grip
Rail
Metal
Rail
Handle
Metal Handle
Stop
Stop
FIG. 7E
FIG. 7E
Handle
Stop
Handle
Stop