Mellerware SMARTVAC Manual De Instrucciones página 4

the vacuum off, empty the dust container and clean the
filter.
3.3. Blockages:
3.3.1. In case of any blockages check the following in
this order:
3.3.1.1. Check the vacuum inlet.
3.3.1.2. Remove the dust bin and check the dust bin
inlet.
3.3.1.3. Ensure that the filter is clean.
3.3.1.4. Check the accessories for any obstructions.
3.3.1.5. If there is still a blockage after following these
steps please contact the manufacturer or its service
agent or a similarly qualified person.
3.4. Operating instructions:
3.4.1. Wall mounting the docking station:
NB – This is entirely optional!!
3.4.1.1. The charging cradle is equipped with wall
mount feature which is optional.
3.4.1.2. Drill 2 X 6mm holes into the wall with the
space of 37mm above each other. (Use measuring tape
to ensure the measurements are accurate as they may
differ.)
3.4.1.3. Insert 2 X 6mm wall plugs and 2 X 6mm
screws (ensure that the head of the screw is able to
fit the holes of the cradle. (Screws and plugs not sup-
plied)
3.4.1.4. Ensure that the head off the screw is exposed
enough for the cradle to hang. Push the cradle onto the
screws and pull down until it hooks securely.
3.4.2. Charging:
NB: Only use the supplied charger to charge this
unit!
3.4.2.1. Insert the adaptor into the correct wall socket.
3.4.2.2. Ensure the vacuum is switched off. Place
31350_IM.indd 4
the vacuum onto the docking station and push down
until the charging connector clicks into the back of the
vacuum.
3.4.2.3. Once connected, the red light on the vacuum
will illuminate.
3.4.2.4. Charge for at least 8 hours.
3.4.2.5. For efficient cleaning, please keep the usage
time to +/- 12 minutes.
3.4.3. Vacuuming dry material:
3.4.3.1. Lift and remove the vacuum from the docking
station.
3.4.3.2. Attach the soft brush or crevice tool to the
suction nozzle to reach confined spaces.
3.4.3.3. Switch the vacuum ON using the ON/OFF
switch.
3.4.3.4. Replace the vacuum on the docking station
after use. The LED indicator will illuminate to indicate
the vacuum is being charged.
NOTE: Empty the dust container before returning to
the docking station to ensure the vacuum does not
get blocked.
3.4.4. Vacuuming liquids:
3.4.4.1. Lift and remove the vacuum from the docking
station.
3.4.4.2. Attach the water suction tool to the suction
nozzle.
3.4.4.3. Switch the vacuum on using the ON/OFF
switch.
3.4.4.4. You can now suck up non-flammable liquids
using the water suction tool.
5/31/2017 10:04:03 AM