Laser Devices - Symbol QRG WSS 1000 SYSTEM Manual De Instrucciones

W S S

Laser Devices

Symbol devices using lasers comply with US 21CFR1040.10, and
IEC825-1:1993, EN60825-1:1994+A11:1996. The laser
classification is marked on one of the labels on the device.
Class 1 Laser devices are not considered to be hazardous when used for their
intended purpose. The following statement is required to comply with US
and international regulations:
Caution: Use of controls, adjustments or performance of procedures other
than those specified herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any very
bright light source, such as the sun, the user should avoid staring directly
into the light beam. Momentary exposure to a Class 2 laser is not known to
be harmful.
FCC RF Exposure Guidelines
To comply with FCC RF exposure requirements, this device must
be worn on the user's wrist while it is in use. Other operating
configurations that have not been tested should be avoided.
Tested to comply
with FCC Standards
FOR HOME OR OFFICE USE
FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
1 0 0 0
Radio Frequency
Interference Requirnments
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
74
S y s t e m