KALLISTA P72037 Guia De Instalacion página 3

4" (10.2 cm)
26"-1/2
1/2" (1.3 cm) D.
(67.3 cm)
Anchor Holes
11"
(27.9 cm)
Min
13"
3/8"
(33 cm)
Hot
Max
1-1/4"
OD
1. Preparation
Install the water supplies and drain piping according to the
roughing-in information. Install the supply stops so the handles
will not touch the pedestal when fully open.
Install sufficient backing behind the finished wall to provide a
secure material for the anchoring devices.
Mark the centerline on the floor.
Move the pedestal into position on the marked centerline.
NOTE: The lavatory must be supported by the pedestal.
Apply two self-adhesive gaskets (provided) to each of the three
ribs on the bottom of the basin.
Carefully lift the lavatory into place on the pedestal, and slowly
move the pedestal as required to ensure proper fit.
Level the lavatory.
Locate the two lavatory anchoring holes, and mark the hole
locations on the finished wall.
Carefully remove the lavatory from the pedestal and set aside.
Move the pedestal from the area.
Kallista
2-3/8" (6 cm)
11-9/16"
(29.4 cm)
C
L of Backing
3" (7.6 cm)
7-7/16"
8"
(18.9 cm)
(20.3 cm)
33-13/16"
3/8" Cold
(85.9 cm)
4" (10.2 cm)
Finished Floor
3
Finished Wall
7"
(17.8 cm)
4-3/4" (12.1 cm)
1036496-2-B