Mellerware Broomy! Manual Del Usuario página 7

above, they can also be bought
separately from the Technical
Assistance Service.
INSTALLATION
Be sure to remove all packaging
material from inside the appliance.
ASSEMBLING THE APPLIANCE
Insert the battery at the bottom of
–
the handle until you hear a "click".
To release the battery from the
–
body, press the side buttons and
stretch out (Fig.1).
Insert the extension tube (I) to the
–
motor body until you hear a "click".
To release the extension tube from
–
the motor body, press the release
button (H) and pull out (Fig.2).
Insert the motorized brush (K) to
–
the extension tube until you hear
a "click". To release the motorized
brush, press the release button (J)
and pull out (Fig.3).
ASSEMBLING HAND VACUUM
CLEANER
Insert the 2in1 accesory (O) or the
crevice tool (P) to the motor body
until you hear a "click". To release
the accesories, press the release
button and pull out (Fig.4).
CHARGING THE BATTERY
Caution: A new battery is not fully
–
charged and must therefore be
charged before the appliance is
used for the first time.
Charge the battery at an
–
atmospheric temperature of
between 4 and 40°C.
Plug the charger (M) into the mains.
–
A pilot light will come on to indicate
–
that the charger is ready to begin
charging the battery.
Approximately 3 to 4 hours are
–
needed for a complete charge
of the battery. Never attempt to
over-charge the battery (although
it is recommended that the first
charge of the battery be of 5 hours
in duration).
Connect the charger to the jack
–
using the socket on the appliance.
The socket is located at the lower/
–
back part of the appliance.
The pilot light will come on to
–
indicate that the charger is
charging the battery.
At the end of the time period
–
specified above, remove the
battery from the charger.
When the battery is charged
–
disconnect the charger from the
mains supply.
NB: Do not use the appliance while
–
it is connected to the charger.
Instructions for use
BEFORE USE
Before using this product for the
first time, it is important to make a
full charge of batteries.
USE
Turn the appliance on, by pressing
–
and holding the on/off button (A).
EN ES