Discontinuing A Measurement - Microlife BP 3AX1 Manual De Instrucciones

A long beep sounds when the measurement has
been completed. The systolic and diastolic blood
pressure and pulse rate appear in the display.
The measurement reading remains on the display for
approximately 30 seconds. If no button is pressed
during the 30-second period the instrument switches
itself off in order to preserve the batteries.
When the unit is set to Average (MAM) Mode, three
separate measurements take place as explained
under 5.4.
If the data of each cycle differ too much
from each other, a fourth measurement is
performed before the result is displayed. In
rare cases when the blood pressure is so
unstable that even after four
measurements the data vary too much, an
error message is displayed. Refer to Error
Messages and Malfunctions (Section 7) at
the end of this manual.

5.6. Discontinuing a measurement

If it is necessary to interrupt a blood pressure measurement for any reason, for example if the patient
feels unwell, press the O/I button. The device immediately lowers the cuff-pressure and enters into
sleep mode.
12
3/03
Countdown
timer
Measurement
number
MAM
15:48
124
sys mmHg
73
dia mmhg
77
pul /min.
15