Mode Of Operation; Maintenance And Environmental Protection - Meister I-DRILL MAS 12ib Traducción De Las Instrucciones De Servicio Originales

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
5450480-Akku-Schra-man.qxd
10 – Mode of operation
Electronic rotation speed regulation
Using the electronic rotation speed
regulation (3), you can adapt the rotation
speed continuously to the respective job.
• Light pressure on the switch (3) = low
rotation speed, in order to loosen
stuck bolts.
• Switch pressed hard = highest
possible rotation speed, for boring.
CAUTION! Avoid the motor
coming to a standstill under
loading when boring or screw-driving!
Clockwise/anti-clockwise run
You determine the rotation direction with
the aid of the slide switch (4) above the
operating switch.
PLEASE NOTE! Change rotation
direction only with motor stopped!
• Screw-driving in bolts: Slide switch to
Position R.
• Turning off bolts: Slide switch to
Position L.
• Safety position: Switch middle
position; in this position of the slide
switch the device cannot be put into
70
operation, e.g. in case of work
03.08.2010 12:19 Uhr
HI/LO switching (11)
With the HI/LO switch, two different
speed ranges can be selected.
• Switch position LO: 0–350 rpm for
• Switch position HI: 0–1200 rpm for
The speed range to be selected is
determined by the respective material
and the planned activity, and is to be
determined through work on a
specimen.
11 – Maintenance and
Clean the case only with a damp cloth –
Do not use solvents! Then dry well. To
maintain capacity, we recommend
completely discharging and recharging
the battery every two months. Store
only fully charged batteries. They should
therefore be recharged from time to
time. The place of storage must be dry;
the ambient temperature must not fall
below 0 °C or rise above 40 °C.
work should not be disposed of in the
household waste! They
are to be collected
separately, in accordance
with the 2002/96 EC
directive for the disposal
of electrical and
electronic waste, and
Seite 70
breaks, bit or drill change.
turning screws in and out
screw-driving and drilling
CAUTION! Carry out changeover
with motor stopped only.
environmental
protection
CAUTION! Electrical and battery
operated units that no longer
loading