Elite mag Instrucciones página 8

EN
Congratulations on your purchase of
an Elite hometrainer
Do not stop the rotation of the bicycle
wheel by using caliper or disk brake. This
seriously damages the roller and the tire
The resistance unit may warm-up while in
use. Let it cool down before handling it and
touching the flywheel
There are no user serviceable parts. The
warranty is void if opened or tampered for
any reason
Check the presence of all the following
components:
N°1 resistance unit (Rif. A)
N°1 parts bag:
1 Allen wrench
2 washers M6 (Rif. B)
2 M6 bolts (Rif. C)
4
IMPORTANT
INTRODUCTION
FITTING THE UNIT
• Resistance unit with 30 mm diameter roller.
• Check the other instruction manual for
assembly instruction of the resistance unit
to the trainer frame.
• Pay careful attention when placing the
resistance unit remote control to the
handlebar (fig. 1), avoiding contact between
the cable and the moving parts of the
bicycle.
• If the handlebar diameter is such that the
clamp of the remote regulation shift cannot
be tightened, either one or both of the rub-
ber linings on the clamp may be removed,
allowing it to be adapted to larger diame-
ters (fig.2).
• Now you may begin training. Resistance
can be adjusted from a minimum (value 1)
to a maximum (value 5).
BICYCLE REMOVAL
• Remove the remote regulation shifter
from the handlebar.