Idiomas disponibles
Idiomas disponibles
Position the plates for
best fit inside the tracks.
or
note:
If screws seem too short and
are not engaging the plate,
take out screw, remove plastic
spacer, use washer only.
In some cases, it may
be easier to assemble
plates, screws, and
bases before sliding onto
tracks.
Installation Tips:
CRoSSBaR SPRead:
The distance between the Yakima
crossbars is determined by the
accessories you wish to carry.
The Crossbar Spread Table (Fit List or
Catalog) will tell you how much crossbar
spread your accessories require.
You aRe now ReadY to PRoCeed to SKYLIne oR ContRoL toweR InStRuCtIonS
1033031B-2/6
Replace end caps.
Load LoCatIon:
For ease of loading, consider where
the most convenient placement of your
load would be before completing the
Install screw with spacer
and washer into pad.
Engage the screw with
provided wrench. Do
not fully tighten.
installation.
Align screws in Landing
Pads with plates.
Arrange Landing Pads on the tracks in the
approximate positions where the SkyLine or
Control Towers will be attached.
note:
do not fully tighten. Final
adjustments will be made
after towers are installed.
USE CAUTION whEN
OPENINg yOUR hATCh.
On some vehicles,
hatch interference with
accessories is unavoidable.
